News Center

News Center

Professional production of industrial brush rollers, rubber rollers, conveyor rollers and other mechanical accessories

The following is to explain to you about the use and maintenance of steel wire roller brush

Release time:

2023-02-09

The following to explain to you aboutSteel wire roller brushWays of use and maintenance

Brief descriptionsteel wire rollBrush the use of methods and protection

Although the press has an important influence in the PCB industry, CCL industry or stainless steel and metal plate processing industry, in order to really exert the influence of the press, in addition to choosing a good quality steel roller brush, there is also how to use the steel roller brush correctly. The edge identity of the brush.

Steel wire roller brush

1. method of use: 1. please press the wire roller brush face or hole on the steering mark, the correct installation of wire roller brush.

2. When installing the wire roller brush on the brush brake, the brush surface needs to be kept level.

3. Please install the wire rope brush according to the requirements of the equipment manufacturer and follow the corresponding safety regulations.

4. Before installing the steel wire roller brush, do not remove the protective film to prevent the steel wire roller brush from being dirty.

5. Usesteel wire rollBefore brushing, you must turn on the water source switch to spray water. In addition, pay attention to check the nozzle frequently to ensure an adequate supply of cold water. This is very important to reduce nylon pollution plug holes and reduce the wear of steel wire rollers!

6. Place the substrate on the upper (lower) side of the steel wire roller brush, so that the substrate does not move, and startsteel wire rollBrush, at this time, the wire roller brush and the substrate contact scratch width should be between 8-16mm.

7. Please regularly check the brush of the wire rope roller and its back pressure wheel, and replace the severely worn back pressure wheel in real time. The disobedience between the wire brush and the back pressure wheel leads to scratches.

8. If the pressure of the wire rope roller brush is increased indiscriminately, the bristles of the wire rope roller will become dirty, resulting in the wear of the back pressure roller and the breakage of the edge of the nylon fiber hole.

9. When the handling speed is too fast, please pay attention to excessive grinding plate surface.

10. When placing the backing plate, please master the skill of evenly placing the backing plate with the width of the carrying wheel offset up and down, left and right, which can not only reduce the wear of the steel wire roller brush, but also prolong the service life of the steel wire roller brush and the back pressure wheel.

　　steel wire rollBrush maintenance

2. protection:

1. After the steel roller brush is used for a period of time, if the user does not place the board for average, the outside of the brush roller will be worn out and cause scratches. At this time, the steel roller brush must be repaired.

2. The maintenance method of general nylon needle-shaped polishing brush roller and nylon washing steel roller brush is to remove the steel roller brush and send it to the manufacturer for maintenance.

3. The non-woven steel wire roller brush can be repaired into a brush brake through the entire brush plate.

Xiao Bian did not introduce much. If you still have other questions, it doesn't matter to call our website customer service immediately. Our company has professional people to solve your doubts. You can pay attention to our company. More industry knowledge and our company activities will be sent out in the first place. Well, I wish everyone good health and good mood every day!