News Center

News Center

Professional production of industrial brush rollers, rubber rollers, conveyor rollers and other mechanical accessories

To explain to you about the use of steel wire roller brush and production process

Release time:

2023-02-09

To explain to you about the use of steel wire roller brush and production process

Use of steel wire roller brush

The traditional process of making travellers is to use special equipment to fix the bristles on a U-shaped stainless steel rod, and then wind them on a roller shaft. The two ends are welded firmly with a sub-pot. During the winding process of the steel belt, the company uses German automatic coiling The machine replaces the Guangdong semi-automatic coiler, and the double steel belt winding technology solves the phenomenon of wire diameter limitation and hair loss of some products.

The main use of steel wire roller brush:

1) Grind the surface of the material to remove burrs and other treatments.

2) Throw natural wood grain and metal surface to elm plate, solid wood plate, decorative plate and other surfaces for wire drawing.

3) rust removal and other functions of steel profiles.

steel wire roller brush process:

1. Direct hair planting is the traditional method, which is to plant nylon thread and abrasive thread directly on the drum.

Advantages: The cost of wool planting is high, and it cannot be partially replaced. It is an initial choice.

2. Nylon jacket

Advantages: The production process is simple, and it is currently the main production method of high-temperature nylon filament brush rollers.

Disadvantages: If it is made of poor quality nylon, the nylon will become longer due to the thermal expansion and cooling contraction of the nylon. Even if the sanding rollers are installed on the nylon at both ends of the drum body, the nylon cover will expand and rupture, and the entire sanding roller will be discarded; The strength of saddle nail planting bristles is not high; because the strength of nylon is not high, the cultivation density cannot be increased.

3. Winding type

Advantages: One of the introduced flocking methods is to make the abrasive thread into a metal rod that can be wound, and then wound on the abrasive roller, which is the main production method of abrasive yarn brush roller.

Disadvantages: The wire of the abrasive is stuck on the metal strip, which will cause wire drawing (the wire of the abrasive is pulled out), and the strength is not high. In addition, only the two ends are fixed after winding, so it is difficult to wind firmly in the middle. One end will cause accidents. Although the winding of the new steel wire belt is much improved than the ordinary winding function, the cost is high.

4. Aluminum Brush Curtain-New Sanding Curtain

Advantages: The produced sanding roller is connected by aluminum alloy cylinders. The aluminum alloy substrate of the brush roller of any length can be customized to improve the density of hair planting. Moreover, the hair planting technology used in production will not collapse or lengthen like nylon. The rolling body can check the dynamic balance.

Disadvantages: The manufacturing cost is too high, the technical requirements for workers are high, and it is not suitable for the manufacture of steel wire roller brushes made of metal wire.

The introduction of the steel wire roller brush is introduced here. I hope you have a certain understanding. Well, I wish you a happy life!